Hioki 3158 - Double Action

53
────────────────────────────────────────────────────
4.5 Double Action
────────────────────────────────────────────────────
1
2
4
6
7
8
9
10
11
12
13
14
A
Setting procedure
0: Not set (Initial setting)
1: Set
NOTE
4.5 Double Action
If the Double Action function is set, READY will not light up in the READY state.
READY only lights up for approximately 0.5 seconds after the
STOP
key is
pressed. While READY is lit, press the
START
key to start a test. If the Double
Action function is set, the
STOP
key must be pressed once. Thus, this function
increases the safety of testing by preventing operational errors.
(1) Press
SHIFT
+
STOP
keys while in READY state to display the Optional
function setting screen.
(2) Use the
/ keys to move the flashing cursor to the position shown in the
figure.
(3) Use the
/ keys to set a value at the flashing cursor location.
(4) To complete the optional settings, press
SHIFT
+
STOP
keys. The unit
reverts to the READY state.
The Double Action function can be set in combination with the Momentary-Out
function. If settings are made in this way, press the
START
key within 0.5 seconds
after the
STOP
key is pressed to start a test. Hold down the
START
key during
the test.