Hioki 3158 - Command Summary

101
────────────────────────────────────────────────────
7.6 Command Summary
────────────────────────────────────────────────────
Command Data Explanation Page
*IDN?
Queries manufacturer's name,
model name, and software version.
86
*RST
Performs device initial setting.
86
:VOLT <data>
0: OFF
1: ON
Enables and disables the
Comparative voltage value.
86
:VOLT?
Queries the Comparative voltage
value enablement.
87
:LOW <data>
0: OFF
1: ON
Enables and disables the lower
level value.
87
:LOW?
Queries the lower level value
enablement.
87
:TIM <data>
0: OFF
1: ON
Enables and disables the test time.
88
:TIM?
Queries the test time.
88
:CONF:VOLT
<data>
0.00 - 5.00
( Numerical data in NR2
format, three digits )
The comparative voltage value
( Refer to section 7.5. )
Sets the comparative voltage value.
89
:CONF:VOLT?
Queries the comparative voltage
value enablement.
89
:
CONF:CUPP
<data>
0.1 - 9.9
( Numerical data in NR2
format, two digits )
10 - 120
( Numerical data in NR1
format, two or three digits )
Upper level value ( Refer to
section 7.5. )
Sets the upper level value.
90
:CONF:CUPP?
Queries the upper level value
enablement.
90
:CONF:CLOW
<data>
0.1 - 9.9
( Numerical data in NR2
format, two digits )
10 - 120
( Numerical data in NR1
format, two or three digits )
Lower level value ( Refer to
section 7.5. )
Sets the lower level value.
91
7.6 Command Summary