104
────────────────────────────────────────────────────
8.1 Maintenance
────────────────────────────────────────────────────
Part Life
Start Switch Approx. 500000 cycles
Stop Switch Approx. 500000 cycles
Part (9613/ 9614) Life
Operate Switch Approx. 25000 cycles
Start Switch Approx. 1000000 cycles
Stop Switch Approx. 1000000 cycles
8.1 Maintenance
To ensure the safe operation of this unit, perform maintenance regularly.
･
Be sure to read assiduously the various items highlighted in this manual for
attention, in order to use the unit correctly.
･
If damage is suspected, check the "Troubleshooting" section before contacting
your dealer or Hioki representative.
･
Pack the product carefully so that it will not be damaged during shipment, and
include a detailed written description of the problem. Hioki cannot be responsible
for damage that occurs during shipment. Please refer to "8.3 Troubleshooting" for
points to note during transportation.
･
If the unit has been subject to moisture, or if oil and dust have accumulated in the
unit interior, the danger of electrical shock or fires resulting from the deterioration
of insulation increases greatly. If the unit is ever subject to excessive moisture,
oil, or dust, cease use immediately, and return the unit to us for maintenance.
･
Replaceable Parts
Main parts to be replaced periodically, and their life times:(Useful life depends on
the operating environment and frequency of use. Operation cannot be guaranteed
beyond the following periods)
･
Periodic calibration is necessary to verify and maintain accuracy. If calibration
becomes necessary, return the unit to us for maintenance.
･
This product uses a lithium battery to back up it's memory. As the battery power
is consumed, it's ability to store measurement conditions diminishes. In the event
that measurement conditions can no longer be stored, please contact the
manufacturer for repair service.
･
Spare and replacement parts for this product are guaranteed to be available only
until 7 years after manufacture of this model is terminated.
Cleaning
To clean the product, wipe it gently with a soft cloth moistened with water or mild
detergent. Never use solvents such as benzene, alcohol, acetone, ether, ketones,
thinners or gasoline, as they can deform and discolor the case.
To Next Page
Loading...
