Hitachi UX2 - Page 232

Chapter 9. Environment Setup
9-4
（ｃ）Change Character orientation (switching signal mode)
●Sets the forward and reverse character orientation method when performing reverse
direction printing.
●The "Change mode" selection menu is different depending on the "Change Character
Orientation" set value.
Character orientation by "Change Character Orientation" and "Change mode" combination
Change Character
Orientation
Change mode
Character orientation
Reciprocative printing
signal: OFF
Reciprocative printing
signal: ON
Reverse
direction
printing
OFF = forward
０：ＡＢＣ（→）
１：ＡＢＣ（←）
３： （→）
２： （←）
OFF = reverse
１：ＡＢＣ（←）
０：ＡＢＣ（→）
２： （←）
３： （→）
Normal or
inverted
OFF = normal
０：ＡＢＣ（→）
２： （←）
３： （→）
１：ＡＢＣ（←）
OFF = inverted
２： （←）
０：ＡＢＣ（→）
１：ＡＢＣ（←）
３： （→）
Character
orientation
0⇔3、1⇔2
OFF = normal and
forward
０：ＡＢＣ（→）
３： （→）
１：ＡＢＣ（←）
２： （←）
OFF = inverted and
reverse
３： （→）
０：ＡＢＣ（→）
２： （←）
１：ＡＢＣ（←）
(Example) Assume that the Change Character Orientation is "Reverse direction printing".
⚫ If Change mode is "OFF = forward"
When the reciprocative printing signal is OFF, prints in the forward direction and when the signal
is ON, prints in the reverse direction.
⚫ If Change mode is "OFF = reverse"
When the reciprocative printing signal is OFF, prints in the reverse direction and when the signal is
ON, prints in the forward direction.
For more detail, see "(3) change character orientation (change mode) supplement".
(d) [Print signal type]
● Sets whether to turn ON the IJ printer print output signal when printing is complete or in progress.
print. complete
Outputs for a fixed period of time after printing is complete.
print.-in-progress
Outputs during printing.