TRANSPORTING
6-3
4. Stop the engine. Remove key from switch.
5. Move the control levers several times until hydraulic
pressure in the cylinders is released.
6. Pull pilot control shut-off lever to LOCK position.
7. Close cab windows, roof vent and door, and cover the
exhaust opening, to prevent entry of wind and water.
NOTE: In cold weather, be sure to warm up the ma-
chine before loading or unloading it.
Transporting
CAUTION: Fasten chains or cables to the ma-
chine frame. Do not place chains or cables over
or against the hydraulic lines or hoses.
1. Place blocks in front of and behind the tracks.
2. Fasten each corner of the machine and front at-
tachment to the trailer with a chain or cable
.
M1CC-05-009
To Next Page
Loading...
