Honeywell 2MLF-AV8A User Manual

5. Configuration and Function of Internal Memory
5.5. PUT/GET function block use area (parameter area)
R200 Analog Input Module 2MLF-AV8A, AC8A User's Guide 103
September 2010 Honeywell
2. In case of setting value other than setting range:
− If time average setting range exceeds, then error number 60x shows up.
− If count average setting range exceeds, then error number 70x shows up. At this
time, initial value is applied and calculated.
3. If the Time/Count average process value is not set, initial value is applied and
calculated (Time average: 4, Count average: 2).
4. The following figure is an example for setting count average as 30 at channel 1.
B15 B14 B13 B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1 B0
- - - - - - - - CH# filter constant
Address Description
_Fab_CH0_AVG_VAL CH0 average process value setting
_Fab_CH1_AVG_VAL CH1 average process value setting
_Fab_CH2_AVG_VAL CH2 average process value setting
_Fab_CH3_AVG_VAL CH3 average process value setting
_Fab_CH4_AVG_VAL CH4 average process value setting
_Fab_CH5_AVG_VAL CH5 average process value setting
_Fab_CH6_AVG_VAL CH6 average process value setting
_Fab_CH7_AVG_VAL CH7 average process value setting
_Fab_CH0_AVG_ VAL CH0 average process value setting
At device allocation, ‘a’ means base number, ‘b’ means slot number, where module is installed.

Honeywell 2MLF-AV8A Specifications

General

Brand	Honeywell
Model	2MLF-AV8A
Category	I/O Systems
Language	English