CLSS Gateway - Installation and Users’ Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022 148
Triga Panels Connecting to the Panels
C.13.3 Programming for Annunciator (ANN-PRI)
Programming enables the panel to recognize the CLSS gateway and the annunciator.
C.13.4 To Program for Annunciator
Using the keypad on the panel, you select options on the screens.
1. On the panel, press the Enter button on the keypad.
2. View the panel screen options.
3. On the keypad, press 7 to select
7 = PROGRAMMING MODE
.
4. Enter the panel's password in the
PROGRAMMING
screen.
The default password is: 00000000
5. Select the panel connected with the gateway, if it is a standalone panel.
OR
Navigate in the list of panels and select the panel connected with the gateway if it is a
multi-panel network.
6. Select
1 = MODULE
.
7. Select
2 = ADD MODULE
.
8. Select the module of the gateway from the list.
9. Select the module type.
10.Select
1 = EDIT MODULE
to enter the module details.
11.Follow the on-screen instructions and enter the communication settings.
12.Review the entered details.
CAUTION: BEFORE PROGRAMMING, ENSURE THAT THE ANN-PRI COMMUNICATION CABLE IS
CONNECTED WITH THE PANEL.
To Next Page
Loading...
Need help?
General