CLSS Gateway - Installation and Users’ Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022 52
Modbus Feature Activation Modbus Communications
7. Scroll down to find Modbus Support in the Features tab.
8. Enter the number of support required in the Modbus Support field.
9. Click PURCHASE.
10.Read the Confirmation message and if acceptable, click CONFIRM.
Or
Click CANCEL and repeat the steps from 8 to 10.
11.Wait for the purchase to complete and refresh the page, if required.
12.Verify that the purchased number under Available Features is correct.
7.13.2 To Activate the Modbus Support
1. Tap Perform Feature Activation on the CLSS App’s welcome message.
Figure 7.6: Feature Activation: The First Step
2. Tap Fixed Gateways.
3. Select the site of the gateway.
4. Find and tap the OC of the gateway.
5. Tap ADD ACTIVATION.
6. Tap Modbus Support under the One Time Activations.
7. Tap ACTIVATE.
8. Wait for the activation successful message.
NOTE:
- The gateway must be already installed. If not, install the fixed gateway.
- All the network settings should be configured while installing.
To Next Page
Loading...
