CLSS Gateway - Installation and Users’ Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022 35
Honeywell CLSS Alarm Transmission Services Configurations
Install a Fixed Gateway at the Site
To enable central station communications, a CLSS Gateway must be installed.
1. Log into the Connected Life Safety Services App in your mobile device.
2. Tap the three horizontal dots icon at the top-right side on the All Customers
dashboard.
3. Select Install Fixed Gateway from the pop-up menu.
4. Follow the on-screen instructions to complete the gateway installation in the App.
Configuring the Central Station Communication
A technician or a service provider administrator can configure the central station
communication of the CLSS Gateway.
1. Log onto the CLSS Site Manager.
2. Select the customer from the All Customers list at the top-left side.
3. Select the customer, select the site, and then select the building requiring alarm
transmission.
4. Click the FEATURE ACTIVATION icon at the left navigation bar.
5. Select Installed Gateways and then go to the INSTALLED GATEWAYS section.
6. Find the CLSS Gateway requiring alarm transmission from the gateway list shown.
NOTE: You can skip this procedure if you are activating the central station
communication for a CLSS Gateway that is already installed.
THE FEATURE ACTIVATION ICON
NOTE: To view only those gateways not yet activated, select Show only Gateways without
activations at the right side.
To Next Page
Loading...
Need help?
General