10 MDR 710 – WWL Conveyor | Maintenance Manual | 29349817
November 16, 2020
Whenever you need to install new equipment or perform maintenance on the
equipment, or whenever you need to shut it down for any other reason, a lockout
procedure must be followed. Your employer is required by O.S.H.A. to develop a
written lockout/tagout procedure for this equipment.
1.9 Safety Signs
In an effort to reduce the possibility of injury to personnel working around conveying
equipment, safety signs are placed at various points on the equipment to alert them
of potential dangers. Please check the equipment and note all safety signs. Make
certain all personnel are alerted to and obey these signs. The following illustration
shows pictograms designed by the Conveyor Equipment Manufacturers Association
(CEMA) Safety Committee as a service to the industry. They also mirror, to the
extent practical, the pictograms on the associated CEMA Safety Labels placed on
the equipment. CEMA Safety Posters are also available to place in work areas and
break areas to remind personnel of safe practices.
To Next Page
