2 MDR 710 – WWL Conveyor | Maintenance Manual | 29349817
November 16, 2020
Emphasis is placed on the latest edition of the Occupational Safety and Health
Standards, which is available from the Department of Labor, Washington, D.C.
These standards (found in Part 1910, Title 29 of the Code of Federal Regulations)
contain the current, general industry occupational safety and health regulations set
forth by federal legislation. Also, some of the information contained in this section
has been reprinted from ASME, B20.1 by permission of The American Society of
Mechanical Engineers. All rights reserved.
1.2 For Your Safety
If you are unable to understand the contents of this manual, bring it to the
attention of your supervisor or foreman.
Failure to comply with the instructions and warnings contained in this manual, and
the warnings posted on the machine, could result in death or serious injury. Do not
operate this equipment unless you have read and understood the contents of this
manual.
This manual contains important safety information concerning the use, maintenance,
installation, and operation of this equipment. Read and become familiar with the
contents of this manual before attempting to install, operate, or service this
equipment. It is necessary that all operators and maintenance personnel study the
applicable sections of this manual thoroughly before operating the equipment.
All safety devices, warning lights, and alarms associated with the conveyor system
must be regularly tested (at least monthly) for proper operation and serviced as
needed. If the original safety items become defective or damaged, refer to the
conveyor parts lists or the bill-of-materials for replacement part numbers.
To Next Page
Loading...
