MDR 710 – WWL Conveyor | Maintenance Manual | 29349817 27
November 16, 2020
Results of these general inspections should be documented in the conveyor record
of the unit inspected. Make photocopies of the checklists in the Preventive
Maintenance Checklist section and place them with the equipment.
The probability of mechanical/electrical problems increases during periods of heavy
use. Therefore, an additional inspection immediately before and after these periods
is recommended.
3.2 Maintenance Precautions
You must read and understand these precautions completely before operating,
setting up or performing maintenance on the equipment. Failure to follow this
instruction may result in serious personal injury and/or equipment damage.
• When testing operating performance, do not start the equipment until all
operations and maintenance personnel are notified and clear of the unit being
tested.
• Be certain that required safety guards are never removed without authorization.
• Never run the equipment under production conditions without safety guards in
place.
• Do not make any equipment repairs while the conveyor is running.
• Keep hands, hair, and clothing clear of any moving parts.
• Never attempt to clear load jams while the equipment is running.
• Always use appropriate tools when making repairs or adjustments.
• Observe all warning labels and follow plant safety rules.
• Make sure all connectors are secure and all wires are free from interference,
obstructions, and any moving parts.
To Next Page
