7 Maintenance, care and repairs
Linear actuators MC55
Operating Manual Version 3.3 - November 2014 23
7 Maintenance, care and repairs
The linear actuator requires little maintenance. You do not have to carry our
continuous or periodical maintenance.
8 Spare parts
When ordering accessories and spare parts please quote the specifications
engraved on the type plate of your linear actuator. The specifications on the type
plate are standard for the technical date of linear actuators as well as the
requirements for the public power supply.
Damage to device caused by faulty spare parts!
Spare parts must match the technical data specified by the manufacturer.
• Use genuine spare parts at all times.
2.1 Component parts on page 6
9 Decommissioning and disposal
Dispose of the linear actuator according to national regulations and laws.
10 Removal of faults
10.1 How to remedy faults
If the linear actuator does not work properly follow the sequence of operations
described below in order to remedy the fault:
1 Check whether the linear actuator was correctly assembled.
2 Check the settings for the linear actuator against the specifications on the type
plate.
3 Remedy the fault by following the check list.
10.2 Check list for breakdown on page 24
4 If you are unable to remedy the fault contact the manufacturer.
5 For all queries at the manufacturer’s and when sending back the device please
quote the following :
• SN (serial number = order number)
• Type denomination
• Supply voltage and frequency
• Accessory equipment
• Error report
6 If you are unable to remedy the fault despite inquiry you can send the device to
the manufacturer.
To Next Page
Loading...
