9 Decommissioning and disposal
Linear actuators MC100 • MC103
Operating Manual Version 2.1 - March 2011 31
9 Decommissioning and disposal
Dispose of the linear actuator according to national regulations and laws.
10 Removal of faults
After remedying faults you will have to re-initialise the path measuring system.
5.9 Initialising the path measuring system on page 27
10.1 How to remedy faults
If the linear actuator does not work properly follow the sequence of operations
described below in order to remedy the fault:
1 Check whether the linear actuator was correctly assembled.
2 Check the settings for the linear actuator against the specifications on the type
plate.
3 Remedy the fault by following the check list.
10.2 Check list for breakdown on page 32
4 If you are unable to remedy the fault contact the manufacturer.
5 For all queries at the manufacturer’s and when sending back the device please
quote the following :
• SN (serial number = order number)
• Type denomination
• Supply voltage and frequency
• Accessory equipment
• Error report
6 If you are unable to remedy the fault despite inquiry you can send the device to
the manufacturer.
To Next Page
Loading...
