4 Assembly
Linear actuators MC160 • MC161 • MC163
14 Version 2.1 - March 2011 Operating Manual
8 Adjust the height of the spindle nut (5) with the help of the hand wheel (36) so
that you can remount the bolt (315).
9 Fit on the blank (314)!
How to assemble linear actuator type MC161:
1 Pull off the blank (314).
diagram 6 on page 13
2 Pull out the bolt (315) from the clutch piece (3) or drive it out.
3 Remove the mounting aid (23).
4 Place the hexagon nut (4) and the blank (308) over the valve stem.
5 Push the adapter (3.1) into the groove of the valve stem (18).
6 Screw the hexagon nut (4) spanner width 24 onto the clutch piece(3).
7 Place actuator with crossbeam (2) on valve neck (19).
8 Fix the crossbeam (2) of the actuator with the help of screws(428) spanner width
13 and lock washers (308) on the valve neck (19).
9 Adjust the height of the spindle nut (5) with the help of the hand wheel (36) so
that you can remount the bolt (315).
10 Fit on the blank (314)!
How to disassemble the linear actuator
1 Follow the sequence of operation in reverse order.
To Next Page
Loading...
