5-9
Table 5–7. Problems Using the Floppy Disk Drive
Problem Solution
The floppy drive
does not respond to
commands.
Re-enter the commands and make sure
that you have typed them correctly.
Make sure that you specified the de-
vice file /dev/rfloppy/c201d0s0 for
commands that require a device file
name.
Make sure that the write-protect tab is
set to write if you are trying to copy
data to a floppy diskette.
Follow the instructions in the section
entitled “Running System Verification
Tests” later in this chapter to verify
that the floppy drive is functioning
properly.
If problems persist, contact your system administrator or call
your designated service representative.
To Next Page
Loading...
