4-8
Formatting a New Diskette
You must always format a new floppy diskette with the mediainit
utility before using it. To format a new floppy diskette follow these
steps:
1. Log in as root.
2. Make sure that the write-protect tab on the floppy diskette is in
the write position, as shown in Figure 4–1.
3. Insert the diskette into the floppy disk drive.
4. In a terminal window, execute mediainit with an interleave of 2
by entering the following:
mediainit –i 2 devicefile
Enter
where devicefile is the device file as listed by sam.
Transferring Data To and From a Floppy Diskette
This section describes how to transfer data to and from your floppy
diskette (saving and restoring) using the HP-UX tar command with
your floppy drive’s device file.
You need to set the write protect tab to the write position to transfer
data to the diskette. The write-protect tab can be in either position
when restoring data from a diskette or listing the files on a diskette.
The tar (tape file archiv-
er) command saves files
to a floppy diskette, re-
stores files from a floppy
diskette, or lists files on
a floppy diskette.
To Next Page
Loading...
Need help?
General
