5-4
Table 5–2. Problems Loading and Booting the Operating System
Problem Solution
The power LED is
lit, and text appears
on the screen, but
more than two min-
utes have passed
with no sign of
system activity.
The system stops or
hangs while booting.
Make sure that all SCSI devices are set
to the proper SCSI ID. (See Appendix
C for default SCSI ID settings.)
Check that all SCSI devices are cor-
rectly cabled. Check that the SCSI bus
is correctly terminated. (See Appendix
C for information on SCSI cabling and
termination.)
Follow the instructions in “Dealing
With a Boot Failure,” later in this
chapter.
If problems persist, contact your system administrator or call
your designated service representative.
To Next Page
Loading...
