D-33
Displaying and Setting the Security Mode
The SECure flag is a variable stored in non–volatile memory. (Non–
volitalmemory retains its contents even after power is turned off.) If
you reset this flag to a new value, the change takes effect the next
time you reboot the workstation.
When the SECure flag is set to on, autoboot and autosearch are
enabled and cannot be stopped. The system boots from the default
boot paths regardless of user intervention.
To display the current setting for the SECure flag, enter the follow-
ing command:
secure
To set the SECure flag on or off, enter one of the following:
secure on
secure off
To Next Page
Loading...
