C-16
Ultra, Wide–SE SCSI Bus Length
Follow these instructions to calculate your total UWSE SCSI bus
length for the UWSE SCSI bus on your system using Table C–8:
1. List all of your internal UWSE SCSI devices in the first column.
2. In the second column, write the lengths of the internal UWSE
SCSI bus that correspond to your devices.
3. In the third column, write down the lengths of the UWSE SCSI
interconnect cables you are using for your installation. (Cable
lengths are listed in subsection “Cables” in the “SCSI Restric-
tions” section.)
4. Add up all of the numbers in the second column and write that
number on the subtotal line at the bottom of the column. Do the
same for the third column.
5. Add the subtotals together and write the total in the Total SCSI
Bus Length box.
NOTICE: The total length of the UWSE SCSI bus must
not exceed 3 meters (9.84 feet). If the number
you write for Total SCSI Bus Length is greater
than 3 meters (9.84 feet), try configuring your
installation with shorter cables.
If you have problems, call your designated service representative.
To Next Page
Loading...
Need help?
General
