B-32
Installing a Hard Disk Drive
Perform the following steps to install a hard disk drive.
NOTICE: Before opening the system unit, follow the
instructions in “Checking the SCSI IDs,” earlier
in this appendix, to determine the SCSI IDs
currently in use on your workstation.
1. Open the system unit according to the directions in “Opening the
System Unit,” earlier in this appendix.
2. Unscrew the two captive screws on the left side of the Storage
Assembly and pull down the drawer ejector handle on the right
side of the Storage Assembly, as shown in Figure B–19.
The Storage Assembly slides partway out of the drawer.
To Next Page
Loading...
Need help?
General
