HP 53131A - Page 156

Chapter 2 Operating Your Universal Counter
Preset Values After Power-Up and *RST
2-80 Operating Guide
2
Phase Arming Parameters
Phase arm yes IMMediate AUTO no
Phase ext start arm slope yes POS POS no
Time Interval, Rise, Fall, Pulse,
Dutycycle Arming Parameters
Time Interval arm yes ________ AUTO no
Time Interval start arm yes IMMediate ________ no
Time Interval ext start arm slope yes POS POS no
Time Interval Only Arming
Parameters
Time Interval delay enable yes ________ OFF no
Time Interval stop arm yes IMMediate ________ no
Time Interval delay yes 10.E-3s 10.E-3s no
Input Coupling Parameters
Channel 1 input coupling yes AC AC no
Channel 2 input coupling yes AC AC no
Input Impedance Parameters
Channel 1 input impedance yes 1E+6 Ohms 1E+6 Ohms no
Channel 2 input impedance yes 1E+6 Ohms 1E+6 Ohms no
Input Attenuation Parameters no
Channel 1 input attenuation yes X1 X1 no
Channel 2 input attenuation yes X1 X1 no
Table 2-7A. HP 53131A (and HP 53132A With S/N Prefix Below 3646) Preset Values (continued)
Description
In
Save/Recall
Value at *RST
(HP-IB Reset)
Value at
Power-Up
In
Non-Volatile
Memory