Chapter 1 Getting Started
Making Measurements
Operating Guide 1-29
1
Setting the Counter to Flag On Limits But Continue
Measuring
Perform the following steps to select the GO ON choice in the ON FAIL
display if you want the Counter to continue measuring even though an
measurement result exceeds the limits previously entered.
The current modified measurement of the input signal applied to
CHANNEL 2 is displayed.
Since the Counter is now in the go-on-fail mode, the Limit annunciator in
the display will light each time a measurement exceeds the limits you set.
However, the Counter will continue to make measurements.
Limit
Modes
Run
Freq Ch 2
M
Gate
To Next Page
Loading...
Need help?
General
