Chapter 1 Getting Started
Making Measurements
Operating Guide 1-21
1
Entering the Offset Value
To demonstrate the Offset Math operation, set the Offset to 1 MHz as
shown in the following steps.
At this point, pressing the
s
key will cause the Counter to display the full
display of the Offset value as shown in the following step.
Press the
s
key six more times to cause the Counter to display your entry
in Mega units as shown in the following step.
The leftmost “0” digit in the OFFSet display is highlighted, indicating that
if you press
d
key once the displayed value will increase to 1 Mega
(that is, 1E6) as shown in the following step.
NOTE
BE SURE to press the Enter key to enter the 1 Mega value.
The Offset is now set to 1 Mega.
Scale &
Offset
M
Enter
M
M
To Next Page
Loading...
Need help?
General
