Chapter 1 Getting Started
Making Measurements
1-20 Operating Guide
1
Entering the Scale Value
To demonstrate the Scale Math operation, set Scale to 10 as shown in the
following steps.
Press and hold the
d
key until the value of Scale is 10 as shown in the
following step.
NOTE
BE SURE to press the Enter key to enter the value of 10.
The Scale is now set to 10, and MATH has been enabled.
The Scale & Offset indicator is now lit to show that MATH is enabled.
Since MATH is enabled, the results are being scaled and offset.
Scale &
Offset
Enter
To Next Page
Loading...
