Chapter 1 Getting Started
Making Measurements
Operating Guide 1-19
1
Selecting Input Sensitivity
Starting the Measurement
The Run key initiates repetitive measurements, and is described in the
section titled “To Control Measurement” at the end of this chapter.
To Select Scale and Offset
The Scale & Offset key allows for multiplication and addition,
respectively, of the measurement by user-specified constants.
Modification of the displayed measurement by these Math operations is
represented by the following equation:
(Measurement
×
Scale) + Offset = Displayed Results
The Scale and Offset Math operations can be used, for example, to
subtract systematic errors or display the percentage difference between
signals.
Trigger
Sensitivity
Display 1, 7/13/92
Display 1, 7/13/92
Display 1, 7/13/92
Run
Freq
MHz
Ch 2
Gate
To Next Page
Loading...
