Contents
Operating Guide vii
Example Procedure for Turning Off Math Mode 2-30
Example Procedure for Setting the Offset From
the Last Measurement Value 2-31
Overview of Statistics (Stats) Menu 2-32
To Use the Stats Menu for Automatic and Continuous
Statistical Analysis 2-33
Example Procedure for Computing Stats 2-33
Example Procedure for Easy Viewing of Stats 2-34
Example Procedure for Filtering Data (Using Limits)
During Stats 2-35
Example Procedure for Configuring SINGLE to Initiate
N Measurements 2-36
Example Procedure for Turning Off Stats Mode 2-36
Using the LIMITS Menu Keys 2-37
Overview of Limits Menus 2-37
To Set and Use Automatic Limit Testing 2-38
Limits Testing Example 1—Flag and Stop Measuring
On Limits 2-38
Limits Testing Example 2—Flag On Limits but
Continue Measuring 2-40
Limits Testing Example 3—Use Analog Graph
Display While Adjusting Input Signal 2-40
Limits Testing Example 4—Selecting Filtering
Conditions of Stats Computation 2-42
Limits Testing Example 5—Sending the Limit-Detect
Output to the RS-232 Serial Port 2-43
Using CHANNEL 1 and CHANNEL 2 Input
Conditioning Keys 2-44
Overview of Trigger/Sensitivity Menu 2-44
To Use the Trigger/Sensitivity Keys to Adjust Counter’s
Triggering Level 2-48
Example Procedure for Setting Trigger Voltage and
Sensitivity Levels 2-48
To Next Page
Loading...
