3
• Each Unicode character takes the space of two regular characters.
• To use Unicode characters or symbols in an interface description, install the specific input method
editor and log in to the switch through remote login software that supports the character type.
• When the length of a description string reaches or exceeds the maximum line width on the terminal
software, the software starts a new line, possibly breaking a Unicode character into two. As a result,
garbled characters may be displayed at the end of a line.
Description
Use description to change the description of the interface.
Use undo description to restore the default.
The default description of an interface is the interface name plus Interface. For example, Ethernet1/0/1
Interface.
Related commands: display interface.
Examples
# Change the description of interface Ethernet 1/0/1 to lanswitch-interface.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] description lanswitch-interface
display counters
Syntax
display counters { inbound | outbound } interface [ interface-type ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
inbound: Displays inbound traffic statistics.
outbound: Displays outbound traffic statistics.
interface-type: Specifies an interface type.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display counters to display traffic statistics for interfaces.
To Next Page
Loading...
Need help?
General
