75
Ethernet link aggregation configuration
commands
default
Syntax
default
View
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default level
2: System level
Parameters
None
Description
Use default to restore the default settings for an aggregate interface.
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings for Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] default
This command will restore the default settings. Continue? [Y/N]:y
description
Syntax
description text
undo description
View
Layer 2 aggregate interface view, Layer 3 aggregate interface view
To Next Page
Loading...
Need help?
General
