HP 5500 HI Series Command Reference

230
VLAN mapping configuration commands
VLAN mapping is achieved through QoS policies. For QoS policy configuration commands, see ACL
and QoS Command Reference.
qinq enable downlink
Syntax
qinq enable downlink
undo qinq enable
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use qinq enable downlink to enable customer-side QinQ on an Ethernet port.
Use undo qinq enable to disable customer-side QinQ on an Ethernet port.
By default, customer-side QinQ is disabled on Ethernet ports.
Enable or disable customer-side QinQ on one port in Ethernet interface view or on a group of ports in
port group view.
Examples
# Enable customer-side QinQ on port Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] qinq enable downlink
# Enable customer-side QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member ethernet 1/0/1 to ethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable downlink
qinq enable uplink
Syntax
qinq enable uplink
undo qinq enable

HP 5500 HI Series Specifications

General

Brand	HP
Model	5500 HI Series
Category	Switch
Language	English