81
display link-aggregation load-sharing mode
Syntax
display link-aggregation load-sharing mode [ interface [ { bridge-aggregation | route-aggregation }
interface-number ] ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
bridge-aggregation: Displays the load sharing criteria of the aggregation group corresponding to the
specified Layer 2 aggregate interface.
route-aggregation: Displays the load sharing criteria of the aggregation group corresponding to the
specified Layer 3 aggregate interface.
interface-number: Specifies an existing aggregate interface number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display link-aggregation load-sharing mode to display global or group-specific link-aggregation
load sharing criteria.
To display the global link-aggregation load sharing criteria, run the command without the interface
keyword.
To display all the group-specific load sharing criteria, run the command with the interface keyword, but
do not specify a particular interface.
To display the load sharing criterion or criteria of a particular aggregation group, perform the command
with the aggregate interface specified.
The bridge-aggregation or route-aggregation keyword becomes available only after you create Layer 2
or Layer 3 aggregate interfaces on the device.
Examples
# Display the global link-aggregation load sharing criteria.
<Sysname>display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: packet type-based sharing
# Display the default link-aggregation load sharing criteria of the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname>display link-aggregation load-sharing mode interface bridge-aggregation 10
To Next Page
Loading...
Need help?
General
