194
Examples
# Associate VLAN 10 (the super VLAN) with VLAN 3, VLAN 4, VLAN 5, and VLAN 9 (the sub-VLANs).
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] subvlan 3 to 5 9
supervlan
Syntax
supervlan
undo supervlan
View
VLAN view
Default level
2: System level
Parameters
None
Description
Use supervlan to configure the VLAN as a super VLAN.
Use undo supervlan to remove the super VLAN configuration for the VLAN.
To configure a VLAN as a super VLAN, make sure that the VLAN does not contain any Ethernet port. You
cannot assign any Ethernet port to a super VLAN.
You cannot configure a super VLAN as the guest VLAN for a port, and vice versa. For more information
about guest VLANs, see Security Configuration Guide.
You can configure Layer 2 multicast for a super VLAN. However, the configuration cannot take effect.
You can configure DHCP, Layer 3 multicast, and dynamic routing for the VLAN interface of a super VLAN.
However, only DHCP can take effect.
HP does not recommend that you configure VRRP for the VLAN interface of a super VLAN, because the
configuration affects network performance.
Related commands: display supervlan.
Examples
# Configure VLAN 2 as a super VLAN.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] supervlan
To Next Page
Loading...
Need help?
General
