17
duplex
Syntax
duplex { auto | full | half }
undo duplex
View
Ethernet interface view
Default level
2: System level
Parameters
auto: Sets the interface to operate in auto-negotiation mode.
full: Sets the interface to operate in full duplex mode.
half: Sets the interface to operate in half-duplex mode. This keyword is not available for Ethernet copper
ports that are configured with a 1000-Mbps port speed and fiber ports.
Description
Use duplex to set the duplex mode for an Ethernet interface.
Use undo duplex to restore the default duplex mode of the Ethernet interface.
By default, Ethernet interfaces operate in auto-negotiation mode.
Related commands: speed.
Examples
# Configure the interface Ethernet 1/0/1 to operate in full-duplex mode.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] duplex full
flow-control
Syntax
flow-control
undo flow-control
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use flow-control to enable TxRx mode generic flow control on an Ethernet interface.
Use undo flow-control to disable generic flow control on the Ethernet interface.
To Next Page
Loading...
Need help?
General
