262
Service loopback group configuration
commands
display service-loopback group
Syntax
display service-loopback group [ number ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
number: ID of the service loopback group to be displayed. If no service loopback group is specified,
information of all service loopback groups is displayed.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display service-loopback group to display information of the specified service loopback group or all
service loopback groups.
Examples
# Display information of service loopback group 5.
<Sysname> display service-loopback group 5
Service Group ID: 5 Quote Number: 0
Service Type: tunnel
Member Status
--------------------------------------------------------------------------------
Eth1/0/1 Selected
Eth1/0/2 Selected
Table 54 Command output
Field Description
Service Group ID Service loopback group ID
Quote Number Reference count of the service loopback group
To Next Page
Loading...
Need help?
General
