90
interface route-aggregation
Syntax
interface route-aggregation interface-number
undo interface route-aggregation interface-number
View
System view
Default level
2: System level
Parameters
interface-number: Specifies a Layer 3 aggregate interface by its number, in the range of 1 to 128.
Description
Use interface route-aggregation to create a Layer 3 aggregate interface and enter the Layer 3
aggregate interface view.
Use undo interface route-aggregation to remove a Layer 3 aggregate interface.
When you create a Layer 3 aggregate interface, a Layer 3 aggregation group with the same number is
automatically created. Removing the Layer 3 aggregate interface also removes the Layer 3 aggregation
group. At the same time, the member ports of the aggregation group, if any, leave the aggregation
group.
Examples
# Create Layer 3 aggregate interface Route-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1]
lacp period short
Syntax
lacp period short
undo lacp period
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use lacp period short to set the LACP timeout interval on a port to the short timeout interval (1 second).
Use undo lacp period to restore the default setting.
The default LACP timeout interval is the long timeout interval (30 seconds).
To Next Page
Loading...
Need help?
General
