164
parenthesis ((), right parenthesis ()), left bracket ([), right bracket (]), left angle bracket (<), right angle
bracket (>), hyphen (-), underscore(_), plus sign (+), equal sign (=), vertical bar (|), back slash (\), colon
(:), semi-colon (;) quotation marks ("), apostrophe ('), comma (,), dot (.), and slash (/), spaces, and other
Unicode characters and symbols.
Description
Use name to configure a name for the VLAN.
Use undo name to restore the default name of the VLAN.
By default, the name of a VLAN is its VLAN ID, for example, VLAN 0001.
When 802.1X or MAC address authentication is configured on a switch, you can use a RADIUS server
to issue VLAN configuration to ports that have passed the authentication. Some servers can send IDs or
names of the issued VLANs to the switch.
Use VLAN names rather than VLAN IDs to distinguish a large number of VLANs.
Related commands: display vlan.
Examples
# Configure the name of VLAN 2 as Test VLAN.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] name Test VLAN
reset counters interface vlan-interface
Syntax
reset counters interface vlan-interface [ vlan-interface-id ]
View
User view
Default level
2: System level
Parameters
vlan-interface-id: Specifies a VLAN interface number.
Description
Use reset counters interface vlan-interface to clear the statistics on a VLAN interface.
Before collecting the traffic statistics within a specific period of time on an interface, clear the existing
statistics first.
If the vlan-interface-id argument is not specified, this command clears the statistics of all VLAN interfaces.
If the vlan-interface-id argument is specified, this command clears the statistics of the specified VLAN
interface.
Related commands: display interface vlan-interface.
Examples
# Clear the statistics on VLAN-interface 2.
<Sysname> reset counters interface vlan-interface 2
To Next Page
Loading...
Need help?
General
