27
For an Ethernet copper port, use the speed command to set its speed to match the speed of the peer
interface.
For a fiber port, use the speed command to set its speed to match the rate of a pluggable transceiver.
The 10 and 1000 keywords are not applicable to FE fiber ports. The 10 and 100 keywords are not
applicable to GE fiber ports.
Related commands: duplex and speed auto.
Examples
# Configure Ethernet 1/0/1 to operate at 100 Mbps.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] speed 100
Layer 2 Ethernet interface configuration commands
broadcast-suppression
Syntax
broadcast-suppression { ratio | pps max-pps | kbps max-kbps }
undo broadcast-suppression
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
ratio: Sets the broadcast suppression threshold as a percentage of the maximum interface rate, ranging
from 1 to 100. The smaller the percentage, the less broadcast traffic is allowed to pass through.
pps max-pps: Specifies the maximum number of broadcast packets that the Ethernet interface can
forward per second.
• For FE ports, the max-pps argument ranges from 1 to 1,488,10 pps.
• For GE ports, the max-pps argument ranges from 1 to 14,881,00 pps.
kbps max-kbps: Specifies the maximum number of kilobits of broadcast traffic that the Ethernet interface
can forward per second.
• For FE ports, the max-kbps argument ranges from 1 to 1,000,00 kbps.
• For GE ports, the max-kbps argument ranges from 1 to 10,000,00 kbps.
Description
Use broadcast-suppression to set the broadcast suppression threshold on one or multiple Ethernet
interfaces.
Use undo broadcast-suppression to restore the default.
By default, Ethernet interfaces do not suppress broadcast traffic.
To Next Page
Loading...
Need help?
General
