231
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use qinq enable uplink to enable network-side QinQ on an Ethernet port.
Use undo qinq enable to disable network-side QinQ on the Ethernet port.
By default, network-side QinQ is disabled on Ethernet ports.
Enable or disable network-side QinQ on one port in Ethernet interface view or on a group of ports in port
group view.
Examples
# Enable network-side QinQ on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] qinq enable uplink
# Enable network-side QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member ethernet 1/0/1 to ethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable uplink
remark customer-vlan-id
Syntax
remark customer-vlan-id vlan-id
undo remark customer-vlan-id
View
Traffic behavior view
Default level
2: System level
Parameters
vlan-id: Specifies a customer VLAN (CVLAN) ID, ranging from 1 to 4094.
Description
Use remark customer-vlan-id to add a CVLAN marking action to a traffic behavior.
Use undo remark customer-vlan-id to remove the action from the traffic behavior.
The remark customer-vlan-id action cannot be applied to a VLAN or applied globally.
To Next Page
Loading...
Need help?
General
