136
<Sysname> system-view
[Sysname] stp mode stp
stp no-agreement-check
Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Description
Use stp no-agreement-check to enable No Agreement Check on the ports.
Use undo stp no-agreement-check to disable No Agreement Check on the ports.
By default, No Agreement Check is disabled.
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
This feature takes effect only after you enable it on the root port.
Examples
# Enable No Agreement Check on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp no-agreement-check
stp pathcost-standard
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
View
System view
Default level
2: System level
To Next Page
Loading...
Need help?
General
