To Next PageTo Next Page
Need help?Do you have a question about the HP 5820X Switch and is the answer not in the manual?
General| Form Factor | Rack-mountable |
|---|---|
| Power over Ethernet (PoE) | No |
| Flash Memory | 512 MB |
| Redundant Power Supply | Optional |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| IPv6 Support | Yes |
| Layer | 3 |
| Routing Protocol | BGP, IS-IS, OSPF, RIP, VRRP, PIM |
| Remote Management Protocol | SNMP 1, RMON, Telnet, SNMP 3, SNMP 2c, CLI, SSH |
| Features | Quality of Service (QoS), VLAN support, Access Control List (ACL), IPv6 support |
| Compliant Standards | IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3, IEEE 802.3ab, IEEE 802.3z |
| Port Type | 10/100/1000Base-T |
| Power Source | AC power supply |
| Security Features | Access Control List (ACL) |
| Layer Supported | L2/L3 |
Overview of network management and monitoring features for the switch series.
Comprehensive guide to configuring the switch series features.
How to use the ping command to test network connectivity and reachability.
Tracing network paths to identify Layer 3 devices and potential failures.
Utilizing system debugging functions to diagnose and diagnose network faults.
Practical examples demonstrating NQA configuration for various test types.
Practical examples for configuring NTP client/server, symmetric, and broadcast modes.
Steps to enable the PoE function for a PoE interface.
Implementing RMON statistics using Ethernet or history groups for traffic analysis.
Key CWMP functions: auto-configuration, file management, and status monitoring.
Steps for enabling NDP/NTDP globally and configuring parameters for management devices.
Configuration steps for setting up local port mirroring groups.
Steps to mirror traffic to a destination interface using QoS policies.
Checklist of tasks required for configuring NetStream features.
Tasks required for configuring IPv6 NetStream, including enabling and data export.
