What to do if the system LED is blinking yellow or red on my HP Server?
If the system LED on your HP Server is blinking yellow or red, it indicates a problem. To resolve this, you can try clearing the attention condition on the LED by accessing the logs using the 'sl' command in the MP command mode. Alternatively, for system alerts of level 7, resolve the underlying issue and then cycle the power to clear the fault condition.
Provides a general description of the HP 9000 rp3410 and rp3440 servers.
Details procedures for safely unpacking the HP 9000 rp3410 and rp3440 servers.
Outlines essential safety precautions for installing hardware and preventing injury or damage.
Describes the controls and indicators on the server's front panel for operation and status monitoring.
Explains how to remove and replace the system chassis covers and bezels for component access.
Guides users through the process of installing additional internal hard disk drives into the server.
Provides instructions and guidelines for installing DDR SDRAM memory modules in the server.
Details the procedure for installing PCI cards into the server's expansion slots.
Guides users on how to install an additional dual processor module to enhance server performance.
Describes the procedure for replacing the system battery, including safety precautions.
Provides instructions for setting up user-desired configuration parameters using system utilities.
Lists essential information to gather before contacting HP support for troubleshooting assistance.
Explains how to use front panel LEDs to diagnose hardware failures and system status.
Details the AC power requirements and connection points for the server.
Describes the various input/output ports available on the server's core I/O interface.
Introduces the Management Processor (MP) and its role in remote server management and monitoring.
Provides instructions for configuring the IP address for the Management Processor's LAN port.
Explains the different methods for connecting to and accessing the server's Management Processor.
Offers a reference guide to commands available for interacting with the Management Processor.
Details the procedure for initiating the server's boot process using the power switch.
To Next Page
General
