Chapter 3
Preparing Superdome for Booting
Installing and Verifying the PDCA
49
Figure 3-16 Five-Wire Connector
Use the following procedure to install the PDCA:
Step 1. Make sure the circuit breaker on the PDCA is Off.
Step 2. Remove the rear PDCA bezel by removing the two reataining screws.
Step 3. Remove the L bezel that covers the PDCA openings by removing one screw. If two PDCAs are to be
installed, remove both L bezels.
Step 4. Run the power cord down through the appropriate opening in the floor tile.
Step 5. Partially insert the PDCA into its slot.
Step 6. Slip the L bracket under the power cord on the rear of the PDCA.
Step 7. While holding the L bracket in place, insert the PDCA completely into the cabinet and secure the L
bracket with one screw.
11/8/00
60SP047A
PE
L1
L2
L3
N
To Next Page
Loading...
