HP 9000 Superdome - Page 74

Chapter 3
Preparing Superdome for Booting
Installing and Verifying the PDCA
50
If you are installing only one PDCA, insert it into the enclosure on the rear-left side of the cabinet.
Figure 3-17Installing the PDCA
Step 8. Using a T20 Torx driver, attach the four screws that hold the PDCA in place.
Step 9. Plug in the PDCA connector.
Step 10. If required, repeat Step 4. through Step 8. for the second PDCA.
Step 11. Re-install the rear PDCA bezel.
CAUTION Before checking the voltage, make sure the electrical panel breaker is On and the
PDCA breaker is Off.
Step 12. Check the voltage at the PDCA.
1. Using a T20 Torx driver, remove the screw on the hinged panel at the top of the PDCA. Refer to
Figure 3-18.
60RR027B
11/15/01
L
3
-
L
1
L
1
-
L
2
L
2
-
L
3
L
2
-
L
3
L
1
-
L
2
L
3
-
L
1