210
Compatibility information
Command and hardware compatibility
Commands and descriptions for centralized devices apply to the following routers:
• MSR1002-4/1003-8S.
• MSR2003.
• MSR2004-24/2004-48.
• MSR3012/3024/3044/3064.
• MSR954(JH296A/JH297A/JH298A/JH299A)
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
IPv6 basics configuration task list
Tasks at a glance
(Required.) Assigning IPv6 addresses to interfaces:
• Configuring an IPv6 global unicast address
• Configuring an IPv6 link-local address
• Configuring an IPv6 anycast address
(Optional.) Configuring IPv6 ND:
• Configuring a static neighbor entry
• Setting the maximum number of dynamic neighbor entries
• Setting the aging timer for ND entries in stale state
• Minimizing link-local ND entries
• Setting the hop limit
• Configuring parameters for RA messages
• Configuring the maximum number of attempts to send an NS message for DAD
• Enabling ND proxy
• Configuring IPv6 ND suppression
• Configuring IPv6 ND direct route advertisement
(Optional.) Configuring path MTU discovery:
• Configuring the interface MTU
• Configuring a static path MTU for an IPv6 address
• Configuring the aging time for dynamic path MTUs
(Optional.) Controlling sending ICMPv6 messages:
• Configuring the rate limit for ICMPv6 error messages
• Enabling replying to multicast echo requests
• Enabling sending ICMPv6 destination unreachable messages
• Enabling sending ICMPv6 time exceeded messages
• Enabling sending ICMPv6 redirect messages
• Specifying the source address for ICMPv6 packets
(Optional.) Enabling IPv6 local fragment reassembly
(Optional.) Configuring IPv6 load sharing based on bandwidth
To Next Page
