176
Configuring load sharing based on bandwidth
This feature load shares flow traffic among multiple output interfaces based on their load
percentages. The device calculates the load percentage for each output interface in terms of the
interface expected bandwidth.
Devices that run load sharing protocols, such as Locator/ID Separation Protocol (LISP), implement
load sharing based on the ratios defined by these protocols.
To configure load sharing based on bandwidth:
Step Command Remarks
1. Enter system view.
system
-
view
N/A
2. Enable IPv4 load sharing
based on bandwidth.
bandwidth-based-sharing
By default, the IPv4 load sharing
based on bandwidth is disabled.
3. Enter interface view.
interface
interface-type
interface-number
N/A
4. Configure the expected
bandwidth of the interface.
bandwidth
bandwidth
By default, the expected
bandwidth is the physical
bandwidth of the interface.
To Next Page
Loading...
Need help?
General
