HP FlexNetwork MSR2003 User Manual

266
To set the DSCP value for DHCPv6 packets sent by the DHCPv6 client:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the DSCP value for
DHCPv6 packets sent by the
DHCPv6 client.
ipv6 dhcp client dscp
dscp-value
By default, the DSCP value in DHCPv6
packets sent by the DHCPv6 client is 56.
Displaying and maintaining DHCPv6 client
Execute the display commands in any view, and execute the reset command in user view.
Task Command
Display the DHCPv6 client information.
display ipv6 dhcp client
[
interface
interface-type
interface-number ]
Display the DHCPv6 client statistics.
display ipv6 dhcp client statistics [ interface
interface-type interface-number ]
Clear the DHCPv6 client statistics.
reset ipv6 dhcp client statistics [ interface
interface-type
interface-number ]
DHCPv6 client configuration examples
IPv6 address acquisition configuration example
Network requirements
As shown in Figure 106, configure GigabitEthernet 2/0/1 of the router to use DHCPv6 to obtain
configuration parameters from the DHCPv6 server. The parameters include IPv6 address, DNS
server address, domain name suffix, SIP server address, and SIP server domain name.
Figure 106 Network diagram
Configuration procedure
You must configure the DHCPv6 server before configuring the DHCPv6 client. For information about
configuring the DHCPv6 server, see "Configuring the DHCPv6 server."
# Configure GigabitEthernet 2/0/1 to support DHCPv6 rapid address assignment. Enable the
DHCPv6 client to create dynamic DHCPv6 option group 1 for saving configuration parameters.

HP FlexNetwork MSR2003 Specifications

General

Brand	HP
Model	FlexNetwork MSR2003
Category	Network Router
Language	English