HP FlexNetwork MSR2003

46
Step Command Remarks
2. Create a DHCP address
pool and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP
address pool exists.
3. Specify the IP address or
the name of a TFTP
server.
• Specify the IP address of the TFTP
server:
tftp-server ip-address ip-address
• Specify the name of the TFTP server:
tftp-server domain-name
domain-name
You can specify both the IP
address and name of the
TFTP server.
By default, no TFTP server
is specified.
4. Specify the configuration
file name.
bootfile-name
bootfile-name
By default, no configuration
file name is specified.
To specify the configuration file URL in a DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool
and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP
address pool exists.
3. Specify the URL of the
configuration file.
bootfile-name
url
By default, no configuration
file URL is specified.
Specifying a server for DHCP clients
Some DHCP clients need to obtain configuration information from a server, such as a TFTP server.
You can specify the IP address of that server. The DHCP server sends the server's IP address to
DHCP clients along with other configuration information.
To specify the IP address of a server:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool
and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP address
pool exists.
3. Specify the IP address of a
server.
next-server
ip-address By default, no server is specified.
Configuring Option 184 parameters for DHCP clients
To assign calling parameters to DHCP clients with voice service, you must configure Option 184 on
the DHCP server. For more information about Option 184, see "Option 184."
To configure option 184 parameters in a DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool and
enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP address pool
exists.