HP FlexNetwork MSR2003 User Manual

49
Step Command Remarks
2. Create a DHCP user class
and enter DHCP user class
view.
dhcp class
class-name
By default, no DHCP user class
exists.
3. Configure a match rule for
the DHCP user class.
if-match rule
rule-number
{
option
option-code [
hex
hex-string [
mask
mask |
offset
offset
length
length ] ] |
hardware-address
hardware-address
mask
hardware-address-mask }
By default, no match rule is
configured for a DHCP user class.
4. Return to system view.
quit
N/A
5. Create a DHCP address pool
and enter DHCP address
pool view.
dhcp server ip-pool
pool-name
By default, no DHCP address pool
exists.
6. Enable the DHCP user class
whitelist.
verify class
By default, the DHCP user class
whitelist is disabled.
7. Add DHCP user classes to
the DHCP user class
whitelist.
valid class
class-name&<1-8>
By default, no DHCP user class is
on the DHCP user class whitelist.
Enabling DHCP
You must enable DHCP to validate other DHCP configurations.
To enable DHCP:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable DHCP.
dhcp enable
By default, DHCP is disabled.
Enabling the DHCP server on an interface
Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the
interface, the DHCP server assigns the client an IP address and other configuration parameters from
a DHCP address pool.
To enable the DHCP server on an interface:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable the DHCP server on
the interface.
dhcp select server
By default, the DHCP server on
the interface is enabled.
Applying an address pool on an interface
Perform this task to apply a DHCP address pool on an interface.

HP FlexNetwork MSR2003 Specifications

General

Brand	HP
Model	FlexNetwork MSR2003
Category	Network Router
Language	English