HP FlexNetwork MSR2003 User Manual

437
Step Command Remarks
• Configure an IPv4-to-IPv6 source address
dynamic translation policy:
aft v4tov6 source acl { number acl-number |
name acl-name } prefix-nat64 prefix-nat64
prefix-length [ vpn-instance
vpn-instance-name6 ] }
• Configure a NAT64 prefix:
aft prefix-nat64 prefix-nat64 prefix-length
Configuring AFT logging
For security auditing, you can configure AFT logging to record AFT session information. AFT
sessions refer to sessions whose source and destination addresses have been translated by AFT.
To configure AFT logging:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable AFT logging.
aft log enable
By default, AFT logging is
disabled.
Setting the ToS field to 0 for translated IPv4
packets
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the ToS field to 0 for IPv4
packets translated from IPv6
packets.
aft turn-off tos
By default, the ToS field value of
translated IPv4 packets is the
same as the Traffic Class field
value of original IPv6 packets.
Setting the Traffic Class field to 0 for translated
IPv6 packets
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the Traffic Class field to 0
for IPv6 packets translated
from IPv4 packets.
aft turn-off traffic-class
By default, the Traffic Class field
value of translated IPv6 packets is
the same as the ToS field value of
original IPv4 packets.
Displaying and maintaining AFT
Execute display commands in any view and reset commands in user view.

HP FlexNetwork MSR2003 Specifications

General

Brand	HP
Model	FlexNetwork MSR2003
Category	Network Router
Language	English