4. Assemble the outer rails:
a. Attach the left outer rail and the right outer rail to the rear mounting brackets, using two
1/4-20 hex nuts with captive star lock-washers at tached loosely, as shown in Figure 10.Do
not tighten the nuts.
Figure 10 In
stalling the outer rails (HP 10000 series racks)
b. Depending
on the rack you are using, complete one of the following tasks:
• For HP 10000 series racks, install two #10-32 x 1/2-inch Phillips pan-head screws with
captive star lock-washers and two # 10 adapter washers in the upper and lower hole
location
s of the right rail. Then install two #10-32 x 1/2-inch Phillips pan-head screws
with captive star lock-washers and two #10 adapter washers in the upper an d lower
hole locations of the left rail. See Figure 11.
Figure 11 Assemb ling the outer rails (HP 10000 series racks)
8Gb SAN Switch hardware reference manual
33
To Next Page
Loading...
